To ensure the strength and stability of the device, it is important for both the single screw granulator and the power unit to be properly installed.
For long-term fixed operation of the single screw granulator, it is recommended to secure it on a cement foundation. This will provide a solid base and prevent any shifting or movement during operation.
In cases where the single screw granulator needs to be operated on a temporary basis, it should be installed on a base made of Angle iron. This base will provide the necessary support and stability for the granulator.
It is crucial to ensure that the power machine, whether it is a diesel engine or a motor, and the belt pulley groove of the single screw granulator are aligned in the same reverse plane. This alignment is necessary for efficient and effective operation of the granulator.
By following these installation guidelines, the single screw granulator and power unit can function optimally and reliably, ensuring smooth operation and high-quality granulation.
To ensure the durability and effectiveness of the single screw granulator and power unit, certain measures need to be taken. If the single screw granulator is intended for long-term fixed operation, it is crucial to secure it onto a cement foundation. Alternatively, if mobility is required for the unit, it should be installed on a base made of Angle iron. Additionally, it is essential to ensure that the power machine (whether it is a diesel engine or a motor) and the belt pulley groove of the single screw granulator are aligned in the same reverse plane.
Once the single screw granulator device is fully set up, it is important to thoroughly inspect the fasteners of each component. In case any loosening is detected, the fasteners should be promptly tightened. It is also crucial to check the belt tightness to ensure it is appropriate.
Before starting the single screw granulator, a manual test should be conducted by rotating the rotor by hand. This allows for a check on the sensitivity and reliability of the claw, hammer, and rotor operation. Any knocking sound within the crushing room should be investigated. Moreover, it is necessary to ensure that the rotation direction of the rotor aligns with the direction indicated by the machine arrow. Lastly, the smooth operation of both the power machine and the single screw granulator must be verified.
By following these guidelines, the single screw granulator and power unit can be effectively prepared for operation, ensuring their durability and functionality.
It is important to exercise caution when replacing the pulley on the machine. If the speed is too high, it could result in the crushing chamber being blasted, while a speed that is too low may affect the machine's working power. Therefore, it is crucial to assess the speed and its potential impact before making any changes to the pulley.
When starting the single screw granulator, it is recommended to allow it to idle for 2 to 3 minutes before initiating any feeding operations. This ensures a smooth and safe start without any abnormalities. Throughout the operation, continuous monitoring of the single screw granulator is essential.
During the feeding process, it is important to maintain a uniform feed rate to prevent any blockage in the crushing chamber. Additionally, it is advisable to avoid prolonged periods of excessive workload on the machine. Regularly inspect the operation status of the granulator, paying attention to any signs of oscillations, noises, excessive bearing and body temperature, or outward spraying. If any of these issues are identified, it is imperative to stop the machine immediately, perform a thorough check, and rectify the problem before resuming operation.
By following these guidelines, you can ensure the safe and efficient operation of the single screw granulator.
